Dell PowerConnect 8024 Cli Reference Guide

1004 Serviceability Tracing Packet Commands
debug ospf
Use the debug ospf command to enable tracing of OSPF packets received and transmitted by
the switch. Use the “no” form of this command to disable tracing of OSPF packets.
Syntax
debug ospf packet
no debug ospf packet
Default Configuration
Display of OSPF traces is disabled by default.
Command Mode
Privileged EXEC mode.
Usage Guidelines
There are no usage guidelines for this command.
Example
console#debug ospf packet
debug ospfv3
Use the debug ospfv3 command to enable tracing of OSPFv3 packets received and transmitted
by the switch. Use the “no” form of this command to disable tracing of OSPFv3 packets.
Syntax
debug ospfv3 packet
no debug ospfv3 packet
Default Configuration
Display of OSPFv3 traces is disabled by default.
Command Mode
Privileged EXEC mode.
Usage Guidelines
There are no usage guidelines for this command.

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries