Dell PowerConnect 8024 Cli Reference Guide

904 Captive Portal Commands
Captive Portal Status Commands
show captive-portal configuration
Use the show captive-portal configuration command to display the operational status of each
captive portal configuration.
Syntax
show captive-portal configuration cp-id
cp-id
—Captive Portal ID.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
console#show captive-portal configuration 1
CP ID..................................... 1
CP Name................................... cp1
Operational Status........................ Disabled
Disable Reason............................ Administrator Disabled
Blocked Status............................ Not Blocked
Authenticated Users....................... 0
show captive-portal configuration interface
Use the show captive-portal configuration interface command to display information about all
interfaces assigned to a captive portal configuration or about a specific interface assigned to a
captive portal configuration.
Syntax
show captive-portal configuration cp-id interface [ interface ]

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries