496 VLAN Commands
•
groupid
— The protocol-based VLAN group ID, which is automatically generated when you
create a protocol-based VLAN group with the
vlan protocol group
command. To see the
group ID associated with the name of a protocol group, use the
show port protocol all
command.
•
vlanid
— A valid VLAN ID.
Default Configuration
This command has no default configuration.
Command Mode
VLAN Database mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to attach the VLAN ID "100" to the protocol-based VLAN
group "3."
console#vlan database
console(config-vlan)#protocol group 3 100
protocol vlan group
Use the protocol vlan group command in Interface Configuration mode to add the physical
unit/port interface to the protocol-based group identified by
groupid
. A group may have more
than one interface associated with it. Each interface and protocol combination can be
associated with one group only. If adding an interface to a group causes any conflicts with
protocols currently associated with the group, this command fails and the interface(s) are not
added to the group. Ensure that the referenced VLAN is created prior to the creation of the
protocol-based group except when GVRP is expected to create the VLAN.
To remove the interface from this protocol-based VLAN group that is identified by this
groupid
,
use the no form of this command.
If you select all, all ports are removed from this protocol group.
Syntax
protocol vlan group
groupid
no protocol vlan group
groupid
To Next Page
Loading...
