IGMP Snooping Commands 279
Syntax
ip igmp snooping host-time-out
time-out
no ip igmp snooping host-time-out
•
time-out
— Host timeout in seconds. (Range: 2- 3600)
Default Configuration
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The timeout should be more than sum of response time and twice the query interval.
Example
The following example configures the host timeout to 300 seconds.
console(config-if-1/g1)#ip igmp snooping host-time-out 300
ip igmp snooping leave-time-out
Use the ip igmp snooping leave-time-out command in Interface Configuration mode to
configure the leave-time-out. If an IGMP report for a Multicast group is not received within the
leave-time-out period after an IGMP leave was received from a specific port, the current port is
deleted from the member list of that Multicast group. To configure the default leave-time-out,
use the no form of this command.
Syntax
ip igmp snooping leave-time-out [
time-out
|
immediate-leave]
no ip igmp snooping leave-time-out
•
time-out
— Specifies the leave-time-out in seconds. (Range: 1 - 3174)
•
immediate-leave
— Specifies that the port should be removed immediately from the
members list after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
To Next Page
Loading...
