Dell PowerConnect 8024 - Lldp Med Faststartrepeatcount; Lldp Med Transmit-Tlv

354 LLDP Commands
Default Value
By default, notifications are disabled on all supported interfaces.
Usage Guidelines
No specific guidelines.
Example
console(config)#lldp med confignotification
lldp med faststartrepeatcount
This command is used to set the value of the fast start repeat count.
Syntax Description
lldp med faststartrepeatcount count
no lldp med faststartrepeatcount
• count — Number of LLDPPDUs that are transmitted when the protocol is enabled. (Range
1–10)
Command Mode
Global Configuration
Default Value
3
Usage Guidelines
No specific guidelines.
Example
console(config)# lldp med faststartrepeatcount 2
lldp med transmit-tlv
This command is used to specify which optional TLVs in the LLDP MED set are transmitted in
the LLDPDUs. There are certain conditions that have to be met for this port to be MED
compliant. These conditions are explained in the normative section of the specification. For
example, the MED TLV 'capabilities' is mandatory. By disabling this bit, MED is effectively
disable on this interface.