Dell PowerConnect 8024 - Show Arp Access-List; Show Ip Arp Inspection Ethernet

Dynamic ARP Inspection Commands 229
show arp access-list
Use the show arp access-list command to display the configured ARP ACLs with the rules.
Giving an ARP ACL name as the argument would display only the rules in that ARP ACL.
Syntax
show arp access-list [ acl-name ]
acl-name — A valid ARP ACL name (Range: 1–31 characters).
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
There are no user guidelines for this command.
Example
console#show arp access-list
ARP access list H2
permit ip host 1.1.1.1 mac host 00:01:02:03:04:05
permit ip host 1.1.1.2 mac host 00:03:04:05:06:07
ARP access list H3
ARP access list H4
permit ip host 2.1.1.2 mac host 00:03:04:05:06:08
show ip arp inspection ethernet
Use the show ip arp inspection ethernet command to display the Dynamic ARP Inspection
configuration on all the DAI enabled interfaces. Giving an interface argument, it displays the
values for that interface.
Syntax
show ip arp inspection ethernet [ interface ]
• interface — Valid Ethernet port. The full syntax is unit/port.