Dell PowerConnect 8024 - Ipv6 Access-List; Ipv6 Access-List Rename

IPv6 Access List Commands 311
console(Config-ipv6-acl)#
ipv6 access-list
The ipv6 access-list command creates an IPv6 Access Control List (ACL) consisting of
classification fields defined for the IP header of an IPv6 frame. The <name> parameter is a
case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the IPv6 access
list.
If an IPv6 ACL with this name already exists, this command enters Ipv6-Access-List config
mode to update the existing IPv6 ACL.
Use the “no” form of the command to delete an IPv6 ACL from the system.
Syntax
ipv6 access-list name
no ipv6 access-list name
• name — Alphanumeric string of 1 to 31 characters uniquely identifying the IPv6 access list.
Default Configuration
There is no default configuration for this command.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
The following example creates an IPv6 ACL named “DELL_IP6” and enters the IPv6-Access-
List Config mode:
console(config)#ipv6 access-list DELL_IP6
console(Config-ipv6-acl)#
ipv6 access-list rename
The ipv6 access-list rename command changes the name of an IPv6 Access Control List (ACL).
This command fails if an IPv6 ACL with the new name already exists.
Syntax
ipv6 access-list rename name newname