244 Ethernet Configuration Commands
1/g8 Gigabit - Level N/A Unknown Auto Up
1/g9 Gigabit - Level N/A Unknown Auto Up
1/g10 Gigabit - Level N/A Unknown Auto Up
1/g11 Gigabit - Level N/A Unknown Auto Up
1/g12 Gigabit - Level N/A Unknown Auto Up
1/g13 Gigabit - Level N/A Unknown Auto Up
1/g14 Gigabit - Level N/A Unknown Auto Up
1/g15 Gigabit - Level N/A Unknown Auto Up
1/g16 Gigabit - Level N/A Unknown Auto Up
1/g17 Gigabit - Level N/A Unknown Auto Up
1/g18 Gigabit - Level N/A Unknown Auto Up
1/g19 Gigabit - Level N/A Unknown Auto Up
--More-- or (q)uit
The displayed port configuration information includes the following:
show interfaces counters
Use the show interfaces counters command in User EXEC mode to display traffic seen by the
interface. Use the command in either User EXEC mode or Privileged EXEC mode to display
Priority Flow Control (PFC) traffic seen by the interface, including Received PFC Frames and
Transmitted PFC Frames for a given ethernet or port-channel interface.
Syntax
show interfaces counters [ethernet
interface
| port-channel
port-channel-number
]
•
interface —
A valid Ethernet port.
Field Description
Port The port number.
Port Type The port designated IEEE shorthand identifier. For example 1000Base-T refers to 1000
Mbps baseband signaling including both Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
Admin State Displays whether the port is enabled or disabled.
To Next Page
Loading...
