Dell PowerConnect 8024 - Show Ip Mcast Mroute Static

722 Multicast Commands
console#show ip mcast mroute source 10.1.1.1 224.5.5.5
Multicast Route Table
Expiry Up Time
Source IP Group IP Time(secs) (secs) RPF Neighbor Flags
--------- --------- ----------- ----------- ------------ -----
show ip mcast mroute static
Use the show ip mcast mroute static command in Privileged EXEC mode to display all the
static routes configured in the static mcast table if it is specified or display the static route
associated with the particular
sourceipaddr .
Syntax
show ip mcast mroute static [ sourceipaddr ]
• sourceipaddr — IP address of source.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the static routes configured in the static mcast table.
console#show ip mcast mroute static
MULTICAST STATIC ROUTES
Source IP Source Mask RPF Address Preference
--------------- --------------- --------------- ----------
1.1.1.1 255.255.255.0 2.2.2.2 23