IP Addressing Commands 301
Default Configuration
No host is defined.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example defines a static host name-to-address mapping in the host cache.
console(config)#ip host accounting.dell.com 176.10.23.1
ip name-server
Use the ip name-server command in Global Configuration mode to define available IPv4 or
IPv6 name servers. To delete a name server, use the no form of this command.
Syntax
ip name-server
server-address1
[
server-address2 … server-address8
]
no ip name-server [
server-address1 … server-address8
]
•
server-address
—Valid IPv4 or IPv6 addresses of the name server. (Range: 1–255 characters)
Default Configuration
No name server IP addresses are specified.
Command Mode
Global Configuration mode
User Guidelines
Server preference is determined by entry order.
Up to eight servers can be defined in one command or by using multiple commands.
Example
The following example sets the available name server.
console(config)#ip name-server 176.16.1.18
To Next Page
Loading...
