Dell PowerConnect 8024 Cli Reference Guide

174 Address Table Commands
console(config)#interface vlan 8
console(config-if-vlan8)#bridge multicast address
01:00:5e:02:02:03
console(config-if-vlan8)#bridge multicast forbidden address
01:00:5e:02:02:03 add ethernet 2/g9
bridge multicast forbidden forward-unregistered
Use the bridge multicast forbidden forward-unregistered command in Interface Configuration
mode to forbid Forwarding-unregistered-multicast-addresses. Use the no form of this command
to return to the default.
Syntax
bridge multicast forbidden forward-unregistered
no bridge multicast forbidden forward-unregistered
Default Configuration
The default for this command is not forbidden .
Command Mode
Interface configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example forbids forwarding unregistered multicast addresses on VLAN8.
console(config-if-vlan8)#bridge multicast forbidden forward-
unregistered
bridge multicast forward-all
Use the bridge multicast forward-all command in Interface Configuration mode to enable
forwarding of all Multicast packets. To restore the default, use the no form of the bridge
multicast forward-all command.
Syntax
bridge multicast forward-all
no bridge multicast forward-all

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries