Dell PowerConnect 8024 Cli Reference Guide

Multicast Commands 711
ip pimsm dr-priority
The ip pimsm dr-priority command is used to set the priority value for which a router is elected
as the designated router (DR). Use the “no” form of this command to set the priority to the
default.
Syntax
ip pimsm dr-priority priority
no ip pimsm dr-priority
• priority — The election priority (Range: 0–2147483647).
Default Configuration
The default election priority is 1.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ip pimsm dr-priority 12
ip pimsm hello-interval
The ip pimsm hello-interval command is used to configure the PIM-SM Hello Interval for the
specified interface. Use the “no” form of this command to set the hello interval to the default.
This command deprecates the ip pimsm query-interval command.
Syntax
ip pimsm hello-interval interval
no ip pimsm hello-interval
• interval — The hello interval (Range: 0–65535 seconds).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode

Dell PowerConnect 8024 Specifications

General

Switching Capacity	480 Gbps
Stackable	Yes
Device Type	Switch
Enclosure Type	Rack-mountable
Power Redundancy	Optional
Width	17.3 in
Height	1.7 in
Jumbo Frame Support	Yes
Ports	24 x 10 Gigabit SFP+
Management	Web-based GUI, Command Line Interface (CLI), SNMP
VLAN Support	Yes
Power Supply	Internal
Routing Protocol	Static routing
Features	Quality of Service (QoS), VLAN support
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3z
Operating Temperature	0 to 45 °C
Storage Temperature	-20 to 70 °C
Relative Humidity	10% to 90% (non-condensing)
MAC Address Table Size	32, 000 entries