802.1X Commands 541
show dot1x ethernet
Use the show dot1x ethernet command in Privileged EXEC mode to show the dot1x status. The
command also displays a VLAN ID or name as required when RADIUS indicates the Tunnel-
Private-Group-ID for a supplicant.
Syntax
show dot1x ethernet
interface
•
interface
— Specifies a valid interface number. The full syntax is unit/port.
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example shows the status of 802.1X. Because the Admin Mode is MAC-based, the
supplicant MAC address is displayed.
console#show dot1x ethernet 1/g5
Administrative Mode............... Enabled
Port Admin Oper Reauth Reauth
Mode Mode Control Period
------- ------------------ ------------ -------- ----------
1/g5 mac-based Authorized TRUE 300
Quiet Period................................... 60
Transmit Period................................ 30
Maximum Requests............................... 2
Max Users...................................... 16
Supplicant Timeout............................. 30
Server Timeout (secs).......................... 30
MAB mode (configured).......................... Enabled
To Next Page
Loading...
