Dell PowerConnect 8024 - Isdp Timer

192 CDP Interoperability Commands
no isdp holdtime
• time —The time in seconds (range 10–255 seconds).
Default Configuration
The default holdtime is 180 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets isdp holdtime to 40 seconds.
console(config)#isdp holdtime 40
isdp timer
The isdp timer command sets period of time between sending new ISDP packets. The range is
given in seconds. Use the “no” form of this command to reset the timer to the default.
Syntax
isdp timer time
no isdp timer
• time — The time in seconds (range: 5–254 seconds).
Default Configuration
The default timer is 30 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example sets the isdp timer value to 40 seconds.
console(config)#isdp timer 40