Dell PowerConnect 8024 - Sflow Polling (Interface Mode)

Sflow Commands 1011
no sflow rcvr-index polling ethernet interfaces
• rcvr-index — The sFlow Receiver associated with the poller (Range: 1–8).
•
interfaces — The list of interfaces to poll.
•
poll-interval — The sFlow instance polling interval. A poll interval of 0 disables counter
sampling. A value of
n means once in n seconds a counter sample is generated. (Range:
0–86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.
Command Mode
Global Configuration mode.
User Guidelines
This command has no user guidelines.
Example
console(config)#sflow 1 polling ethernet 1/g1-1/g10 200
sflow polling (Interface Mode)
Use the sflow polling command in Interface Mode to enable a new sflow poller instance for this
data source if rcvr_idx is valid. Use the "no" form of this command to reset poller parameters to
the defaults.
Syntax
sflow rcvr-index polling poll-interval
no sflow polling
• rcvr-index — The sFlow Receiver associated with the poller (Range: 1 - 8).
•
poll-interval — The sFlow instance polling interval. A poll interval of 0 disables counter
sampling. A value of n means once in n seconds a counter sample is generated. (Range: 0 -
86400).
Default Configuration
There are no pollers configured by default.
The default poll interval is 0.