Dell PowerConnect 8024 - Timers Spf

780 OSPF Commands
Example
The following example displays the OSPF Virtual Interface information in the system.
console#show ipv6 ospf virtual-link brief
Hello Dead Retransmit Transit
Area ID Neighbor Interval Interval Interval Delay
------- -------- -------- -------- ---------- --------
0.0.0.2 5.5.5.5 10 40 5 1
timers spf
Use the timers spf command in Router OSPF Configuration mode to configure the SPF delay
and hold time. Use the no form of the command to reset the numbers to the default value.
Syntax
timers spf delay-time hold-time
no timers spf
• delay-time — SPF delay time. (Range: 0–65535 seconds)
•
hold-time — SPF hold time. (Range: 0–65535 seconds)
Default Configuration
The default value for delay-time is 5. The default value for hold-time is 10.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the SPF delay and hold time.
console(config-router)#timers spf 20 30