Dell PowerConnect 8024 - Ipv6 Mld-Proxy Unsolicit-Rprt-Interval

IPv6 Routing Commands 663
Syntax
ipv6 mld-proxy reset-status
Command Mode
Interface Configuration (VLAN) mode.
Default Configuration
There is no default configuration for this command.
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan3)#ipv6 mld-proxy reset-status
ipv6 mld-proxy unsolicit-rprt-interval
Use the ipv6 mld-proxy unsolicit-rprt-interval command to set the unsolicited report interval
for the MLD Proxy router. This command is only valid when MLD Proxy is enabled on the
interface. Use the “no” form of this command to reset the MLD Proxy router's unsolicited
report interval to the default value.
Syntax
ipv6 mld-proxy unsolicited-report-interval interval
no ipv6 mld-proxy unsolicited-report-interval
• interval —The interval between unsolicited reports (Range: 1–260 seconds).
Default Configuration
The unsolicited report interval is 1 second by default.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines
Example
console(config-if-vlan3)#ipv6 mld-proxy unsolicit-rprt-interval 10