Dell PowerConnect 8024 - Page 83

Command Groups 83
IPv6 Routing
show ipv6 pimsm interface Displays interface config parameters. PE
show ipv6 pimsm neighbor Displays IPv6 PIMSM neighbors learned on the routing
interfaces.
PE
show ipv6 pimsm rphash Displays which rendezvous point (RP) is being selected for a
specified group.
PE
show ipv6 pimsm rp mapping Displays all group-to-RP mappings of which the router is
aware (either configured or learned from the BSR).
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
clear ipv6 neighbors Clears all entries in the IPv6 neighbor table or an entry on a
specific interface.
PE
clear ipv6 statistics Clears IPv6 statistics for all interfaces or for a specific
interface, including loopback and tunnel interfaces.
PE
ipv6 address Configures an IPv6 address on an interface (including
tunnel and loopback interfaces).
IC
ipv6 enable Enables IPv6 routing on an interface (including tunnel and
loopback interfaces) that has not been configured with an
explicit IPv6 address.
IC
ipv6 forwarding Enables IPv6 forwarding on a router. GC
ipv6 host Defines static host name-to- ipv6 address mapping in the
host cache.
GC
ipv6 mld last-member-query-
count
Sets the number of listener-specific queries sent before the
router assumes that there are no local members on the
interface.
IC
(VLAN)
ipv6 mld last-member-query-
interval
Sets the last member query interval for the MLD interface,
which is the value of the maximum response time
parameter in the groupspecific queries sent out of this
interface.
IC
(VLAN)
ipv6 mld-proxy Enables MLD Proxy on the router. IC
ipv6 mld-proxy reset-status Resets the host interface status parameters of the MLD
Proxy router.
IC
ipv6 mld-proxy unsolicit-rprt-
interval
Sets the unsolicited report interval for the MLD Proxy
router.
IC
ipv6 mld query-interval Sets the MLD router's query interval for the interface. IC
Command Description Mode*