Dell PowerConnect 8024 - Page 81

Command Groups 81
IP Helper
IP Routing
Command Description Mode*
clear ip helper statistics Resets (to 0) the statistics displayed in show ip helper
statistics.
PE
ip helper-address (global
configuration)
Configures the relay of certain UDP broadcast packets
received on any interface.
GC
ip helper-address (interface
configuration)
Configures the relay of certain UDP broadcast packets
received on a specific interface.
IC
ip helper enable Enables relay of UDP packets. GC
show ip helper-address Displays the IP helper address configuration. PE
show ip helper statistics Displays the number of DHCP and other UDP packets
processed and relayed by the UDP relay agent.
PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
encapsulation Configures the link layer encapsulation type for the packet. IC
ip address Configures an IP address on an interface. IC
ip mtu Sets the IP Maximum Transmission Unit (MTU) on a
routing interface.
IC
ip netdirbcast E
nables the forwarding of network-directed broadcasts. IC
ip route Configures a static route. Use the no form of the command
to delete the static route.
GC
ip route default Configures the default route. Use the no form of the
command to delete the default route.
GC
ip route distance Sets the default distance (preference) for static routes. GC
ip routing Globally enables IPv4 routing on the router. GC
routing Enables IPv4 and IPv6 routing for an interface. IC
show ip brief Displays all the summary information of the IP. PE
show ip interface Displays all pertinent information about the IP interface. PE
show ip protocols Displays the parameters and current state of the active
routing protocols.
PE
show ip route Displays the routing table. PE
show ip route preferences Displays detailed information about the route preferences. PE