Dell PowerConnect 8024 - Page 118

118 Using the CLI
• Router OSPFv3 Configuration — Global configuration mode command ipv6 router ospf is
used to enter into the Router OSPFv3 Configuration mode.
•
IPv6 DHCP Pool Mode — Global configuration mode command ipv6 dhcp pool is used to
enter into the IPv6 DHCP Pool mode.
•
Management Access List — Contains commands to define management access
administration lists. The Global Configuration mode command
management access-list is
used to enter the Management Access List configuration mode.
•
Policy-map — Use the policy-map command to access the QoS policy map configuration
mode to configure the QoS policy map.
•
Policy Class — Use the class command to access the QoS Policy-class mode to attach or
remove a diffserv class from a policy and to configure the QoS policy class.
•
Class-Map — This mode consists of class creation/deletion and matching commands. The
class matching commands specify layer 2, layer 3 and general match criteria. Use the class-
map class-map-name commands to access the QoS Class Map Configuration mode to
configure QoS class maps.
•
Stack — Use the stack command to access the Stack Configuration Mode.
•
Ethernet — Contains commands to manage Ethernet port configuration. The Global
Configuration mode command
interface ethernet enters the Interface Configuration mode
to configure an Ethernet interface.
•
Port Channel — Contains commands to configure port-channels, i.e., assigning ports to a
port-channel. Most of these commands are the same as the commands in the Ethernet
interface mode and are used to manage the member ports as a single entity. The Global
Configuration mode command
interface port-channel is used to enter the Port Channel
mode.
•
Tunnel — Contains commands to manage tunnel interfaces. The Global Configuration mode
command interface tunnel enters the Tunnel Configuration mode to configure an tunnel type
interface.
•
Loopback — Contains commands to manage loopback interfaces. The Global Configuration
mode command interface loopback enters the Loopback Configuration mode to configure an
loopback type interface.
•
SSH Public Key-chain — Contains commands to manually specify other switch SSH public
keys. The Global Configuration mode command
crypto key pub-key chain ssh is used to
enter the SSH Public Key-
chain configuration mode.
•
SSH Public Key-string — Contains commands to manually specify the SSH Public-key of a
remote SSH Client. The SSH Public-Key Chain Configuration mode command
user-key
command is used to enter the SSH Public-Key Configuration mode
.
• MAC Access-List — Configures conditions required to allow traffic based on MAC addresses.
The Global Configuration mode command
mac-access-list is used to enter the MAC Access-
List configuration mode.