Dell PowerConnect 8024 - Page 120

120 Using the CLI
Command Mode Access Method Command Prompt Exit or Access
Previous Mode
User EXEC The user is
automatically in User
EXEC mode unless the
user is defined as a
privileged user.
console>
logout
Privileged EXEC Use the enable
command to enter into
this mode. This mode is
password protected.
console#
Use the exit
command, or press
<Ctrl>+<Z> to
return to the User
EXEC mode.
Global Configuration From Privileged EXEC
mode, use the configure
command.
console(config)#
Use the exit
command, or press
<Ctrl>+<Z> to
return to the
Privileged EXEC
mode.
Line Interface From Global
Configuration mode,
use the line command.
console(config-
line)#
To exit to Global
Configuration
mode, use the exit
command, or press
<Ctrl>+<Z> to
Privileged EXEC
mode.
Management Access-List From Global
Configuration mode,
use the management
access-list command.
console(config-
macl)#
To exit to Global
Configuration
mode, use the exit
command, or press
<Ctrl>+<Z> to
Privileged EXEC
mode.
Policy-Class-Map From Global
Configuration mode,
use the policy-map class
command.
console(config-
policy-classmap)#
To exit to Global
Configuration
mode, use the exit
command, or press
<Ctrl>+<Z> to
Privileged EXEC
mode.