Dell PowerConnect 8024 - Page 379

Port Channel Commands 379
Syntax Description
show interfaces port-channel [ port-channel number ]
•[ port-channel-number ] — Number of the port channel to show. This parameter is optional. If
the port channel number is not given, all the channel groups are displayed. (Range: Valid port-
channel number, 1 to 48)
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC
User Guidelines
No specific guidelines.
Example
Console#show interfaces port-channel
Channel Ports Hashing-mode
------- --------------------------------------- ------------
ch1 Active: 1/e1, 2/e2 1
ch2 Active: 2/e2, 2/e7 Inactive: 3/e1 2
ch3 Active: 3/e3, 3/e8 3 <default>
ch4 No Configured Ports 5
ch5 No Configured Ports 6
ch6 No Configured Ports 4
ch7 No Configured Ports 3 <default>
ch8 No Configured Ports 3 <default>
Hash algorithm type
1 - Source MAC, VLAN, EtherType, source module and port Id
2 - Destination MAC, VLAN, EtherType, source module and port Id
3 - Source IP and source TCP/UDP port
4 - Destination IP and destination TCP/UDP port