Dell PowerConnect 8024 - Page 62

62 Command Groups
IPv6 ACL
ip default-gateway Defines a default gateway (router). GC
ip domain-lookup Enables IP DNS-based host name-to-address translation. GC
ip domain-name Defines a default domain name to complete unqualified
host names.
GC
ip helper-address Allows the device to forward User Datagram Protocol
(UDP) broadcasts received on an interface.
GC
ip host Configures static host name-to-address mapping in the host
cache.
GC
ip name-server Configures available name servers. GC
ipv6 address Set the IPv6 address of the management interface. GC
ipv6 enable Enable IPv6 on the management interface. GC
ipv6 gateway Configures an IPv6 gateway for the management interface. GC
show arp switch Displays
the entries in the ARP table. PE
show hosts Displays the default domain name, a list of name server
hosts, static and cached list of host names and addresses.
UE
show ip helper-address Displays the ip helper addresses configuration. PE
show ip interface management Displays the management IP interface information. PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*
{deny | permit} Creates a new rule for the current IPv6 access list. v6ACL
ipv6 access-list Creates an IPv6 Access Control List (ACL) consisting of
classification fields defined for the IP header of an IPv6
frame.
GC
ipv6 access-list rename Changes the name of an IPv6 ACL. GC
ipv6 traffic-filter Attaches a specific IPv6 ACL to an interface or associates it
with a VLAN ID in a given direction.
GC
IC
show ipv6 access-lists Displays an IPv6 access list (and the rules defined for it). PE
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 51.
Command Description Mode*