76 Command Groups
802.1X
Command Description Mode*
dot1x mac-auth-bypass Enables MAB on an interface. IC
dot1x max-req Sets the maximum number of times the switch sends an
EAP-request frame to the client before restarting the
authentication process.
IC
dot1x max-users Sets the maximum number of clients supported on the port
when MAC-based 802.1X authentication is enabled on the
port.
IC
dot1x port-control Enables manual control of the authorization state of the
port.
IC
dot1x re-authenticate Manually initiates a re-authentication of all 802.1X-enabled
ports or a specified 802.1X enabled port.
PE
dot1x re-authentication Enables periodic re-authentication of the client. IC
dot1x system-auth-control Enables 802.1X globally. GC
dot1x timeout quiet-period Sets the number of seconds the switch remains in the quiet
state following a failed authentication attempt
IC
dot1x timeout re-authperiod Sets the number of seconds between re-authentication
attempts.
IC
dot1x timeout server-timeout Sets the number of seconds the switch waits for a response
from the authentication server before resending the request.
IC
dot1x timeout supp-timeout Sets the number of seconds the switch waits for a response
to an EAP-request frame from the client before
retransmitting the request.
IC
dot1x timeout tx-period Sets the number of seconds the switch waits for a response
to an EAP-request/identify frame from the client before
resending the request.
IC
show dot1x Displays 802.1X status for the switch or the specified
interface.
PE
show dot1x clients Displays detailed information about the users who have
successfully authenticated on the system or on a specified
port.
PE
show dot1x ethernet Shows the status of MAC Authentication Bypass. PE
show dot1x statistics Displays 802.1X statistics for the specified interface. PE
show dot1x users Displays active 802.1X authenticated users for the switch. PE
dot1x guest-vlan Sets the guest VLAN on a port. IC
dot1x unauth-vlan Specifies the unauthenticated VLAN on a port. IC
To Next Page
Loading...
