EasyManua.ls Logo

Dell PowerConnect 8024 - Page 927

Dell PowerConnect 8024
1132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuration and Image File Commands 927
Syntax
copy
source-url destination-url
{xmodem | tftp:
//ipaddr/filepath/filename
|
sftp|scp:
//username
@
ipaddr/filepath/filename
|
hostname
}
source-url
— The location URL or reserved keyword of the source file being copied. (Range:
1–160 characters.)
destination-url
— The URL or reserved keyword of the destination file. (Range: 1–160
characters.)
ipaddr
— The IPv4 or IPv6 address of the server.
hostname
— Hostname of the server. (Range: 1–158 characters)
filepath
— The path to the file on the server.
filename
The name of the file on the server.
username
— The user name for logging into the remote server via SSH.
The following table lists and describes reserved keywords.
Default Configuration
This command has no default configuration.
Reserved Keyword Description
running-config Represents the current running configuration file.
startup-config Represents the startup configuration file.
startup-log Represents the startup syslog file. This can only be the source of a copy operation.
operational-log Represents the operational syslog file. This can only be the source of a copy
operation.
script
scriptname
Represents a CLI script file.
image Represents the software image file. When "image" is the target of a copy
command, it refers to the backup image. When "image" is the source of a copy
command, it refers to the active image. If this is destination, the file will be
distributed to all units in the stack.
scp: Source or destination URL for an SCP network server.
sftp: Source or destination URL for an SFTP network server.
tftp: Source or destination URL for a TFTP network server. The syntax for this alias is
tftp:
[[//location]/directory]/filename
. An out-of-band IP address can be specifed as
described in the User Guidelines.
xmodem: Source for the file from a serial connection that uses the Xmodem protocol.
backup-config Represents the backup configuration file.
unit Indicates which unit in the stack is the target of the copy command.

Table of Contents

Other manuals for Dell PowerConnect 8024

Related product manuals