Send documentation comments to mdsfeedback-doc@cisco.com
21-16
Cisco MDS 9000 Family Fabric Manager Configuration Guide
OL-17256-03, Cisco MDS NX-OS Release 4.x
Chapter 21 Configuring N Port Virtualization
Configuring NPV
If you choose switches that are NPV disabled and click Next, a warning message appears with a list of
IP addresses of the NPV devices on which NPV will be enabled. Enabling NPV on the switch will result
in reboot of the switch. Boot variables of the switches have to be set, to enable NPV on them through
this wizard. (See Figure 21-12.)
Figure 21-12 Warning to Enable NPV Feature on NPV-Capable Switches
To Next Page
Loading...
Need help?
General
