Cisco Sx350

50
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1001
Rate Limit and Storm Control Commands
50.0
50.1 clear storm-control counters
To clear storm control counters, use the clear storm-control counters command in
Privileged EXEC mode.
Syntax
clear storm-control counters [broadcast | multicast | unicast] [interface interface-id ]
Parameters
•
broadcast—(Optional) Clear Broadcast storm control counters.
• multicast—(Optional) Clear Multicast storm control counters.
• unicast—(Optional) Clear Unicast Unknown storm control counters.
• interface interface-id —(Optional) Clear storm control counters for the
specified Ethernet port.
Command Mode
Privileged EXEC mode
User Guidelines
The switch clears the port counter of a given traffic type when storm control for
this traffic type on this port is enabled.
Use this command to clear the storm control counters when storm control is
running.
Use the clear storm-control counters command to clear all the storm control
counters of all Ethernet ports.