Cisco Sx350

IGMP Snooping Commands
487 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
23
Default Configuration
Learning pim-dvmrp is enabled.
Command Mode
Global Configuration mode
User Guidelines
Multicast router ports are learned according to:
• Queries received on the port
• PIM/PIMv2 received on the port
• DVMRP received on the port
• MRDISC received on the port
• MOSPF received on the port
You can execute the command before the VLAN is created.
Example
switchxxxxxx(config)# ip igmp snooping vlan 1 mrouter learn pim-dvmrp
23.4 ip igmp snooping vlan mrouter interface
To define a port that is connected to a Multicast router port, use the ip igmp
snooping mrouter interface command in Global Configuration mode. To return to
the default, use the no form of this command.
Syntax
ip igmp snooping vlan
vlan-id mrouter interface i nterface-list
no ip igmp snooping vlan vlan-id mrouter interface interface-list
Parameters
• vlan-id —Specifies the VLAN.
• interface-list —Specifies the list of interfaces. The interfaces can be one of
the following types: Ethernet port or Port-channel.