Cisco Sx350

802.1X Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 102
3
Syntax
dot1x system-auth-control
no dot1x system-auth-control
Parameters
N/A
Default Configuration
Disabled.
Command Mode
Global Configuration mode
Example
The following example enables 802.1X globally.
switchxxxxxx(config)# dot1x system-auth-control
3.20 dot1x timeout quiet-period
To set the time interval that the device remains in a quiet state following a failed
authentication exchange, use the dot1x timeout quiet-period command in Interface
Configuration mode. To restore the default configuration, use the no form of this
command.
Syntax
dot1x timeout quiet-period
seconds
no dot1x timeout quiet-period
Parameters
• seconds —Specifies the time interval in seconds that the device remains in
a quiet state following a failed authentication exchange with a client. (Range:
10–65535 seconds).