Cisco Sx350

Introduction
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 28
1
Create a user with user level 1:
Example 2— Switch between Level 1 to Level 15. The user must know the
password:
NOTE If authentication of passwords is performed on RADIUS or TACACS+ servers, the
passwords assigned to user level 7 and user level 15 must be configured on the
external server and associated with the $enable7$ and $enable15$ user names,
respectively. See the Authentication, Authorization and Accounting (AAA)
Commands chapter for details.
CLI Command Modes
The CLI is divided into four command modes. The command modes are (in the
order in which they are accessed):
• User EXEC mode
• Privileged EXEC mode
• Global Configuration mode
• Interface Configuration mode
Each command mode has its own unique console prompt and set of CLI
commands. Entering a question mark at the console prompt displays a list of
available commands for the current mode and for the level of the user. Specific
commands are used to switch from one mode to another.
switchxxxxxx#configure
switchxxxxxx<conf> username john password john1234
privilege 1
switchxxxxxx<conf>
switchxxxxxx#
switchxxxxxx# enable
Enter Password: ****** (this is the password for level 15
- level15@abc)
switchxxxxxx#