Cisco Sx350

IGMP Snooping Commands
493 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
23
Example
The following example disables the IGMP Snooping querier globally:
switchxxxxxx(config)# no ip igmp snooping querier
23.10 ip igmp snooping vlan querier
To enable the IGMP Snooping querier on a specific VLAN, use the ip igmp
snooping vlan querier command in Global Configuration mode. To disable the
IGMP Snooping querier on the VLAN interface, use the no form of this command.
Syntax
ip igmp snooping
vlan vlan-id querier
no ip igmp snooping
vlan vlan-id querier
Parameters
• vlan-id —Specifies the VLAN.
Default Configuration
Disabled
Command Mode
Global Configuration mode
User Guidelines
The IGMP Snooping querier can be enabled on a VLAN only if IGMP Snooping is
enabled for that VLAN.
Example
The following example enables the IGMP Snooping querier on VLAN 1:
switchxxxxxx(config)# ip igmp snooping vlan 1 querier