Cisco Sx350

Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 398
17
Example
The following example sets the error recovery timeout interval to 10 minutes.
switchxxxxxx(config)# errdisable recovery interval 600
17.18 errdisable recovery reset
To reactivate one or more interfaces that were shut down by a given application,
use the errdisable recovery reset Privileged EXEC mode command. A single
interface, multiple interfaces or all interfaces can be specified.
Syntax
errdisable recovery reset {all | port-security | dot1x-src-address | acl-deny
|stp-bpdu-guard | loopback-detection | udld | storm-control | link-flap | interface
interface-id }
Parameters
• all—Reactivate all interfaces regardless of their state.
• port-security—Reactivate all interfaces in the Port Security Err-Disable
state.
• dot1x-src-address—Reactivate all interfaces in the 802.1x Err-Disable state.
• acl-deny—Reactivate all interfaces in the ACL Deny Err-Disable state.
• stp-bpdu-guard—Reactivate all interfaces in the STP BPDU Guard
Err-Disable state.
• loopback-detection—Reactivate all interfaces in the Loopback Detection
Err-Disable state.
• udld—Reactivate all interfaces in the UDLD Shutdown state.
• storm-control—Reactivate all interfaces in the Storm Control Shutdown
state.
• link-flap—Reactivate all interfaces in the link-flap prevention Err-Disable
state.
• interface interface-id— Reactivate interfaces that were configured to be
active, but were shut down by the system.