Cisco Sx350

Ethernet Configuration Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 392
17
17.11 back-pressure
To enable back pressure on a specific interface, use the back-pressure Interface
(Ethernet) Configuration mode command. To disable back pressure, use the no
form of this command.
Syntax
back-pressure
no back-pressure
Parameters
This command has no arguments or keywords.
Default Configuration
Back pressure is disabled.
Command Mode
Interface (Ethernet) Configuration mode
User Guidelines
Back-pressure cannot be enabled when EEE is enabled.
Example
The following example enables back pressure on port gi11.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# back-pressure
17.12 port jumbo-frame
To enable jumbo frames on the device, use the port jumbo-frame Global
Configuration mode command. To disable jumbo frames, use the no form of this
command.