Cisco Sx350

Smartport Commands
1063 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
55
55.3 macro auto persistent
The macro auto persistent Interface Configuration mode command sets the
interface as a Smartport persistent interface. The no format of the command
returns it to default.
Syntax
macro auto persistent
no macro auto persistent
Parameters
This command has no parameters or keywords.
Default Configuration
Persistent is set.
Command Mode
Interface (Ethernet, Port Channel) Configuration mode
User Guidelines
A Smartport’s persistent interface retains its dynamic configuration in the
following cases: link down/up, the attaching device ages out, and reboot. Note that
for persistence and the Smartport configuration to be effective across reboot, the
Running Configuration file must be saved to the Startup Configuration file.
Example
The example establishes two port ranges and makes one persistent and the other
not.
switchxxxxxx(config)# interface range gi11-2
switchxxxxxx(config-if-range)# macro auto persistent
switchxxxxxx(config-if-range)# exit
switchxxxxxx(config)# interface range gi13-4
switchxxxxxx(config-if-range)# no macro auto persistent