Cisco Sx350

DHCP Snooping Commands
337 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
13
This command displays the inactive IP source guard addresses.
Example
The following example displays the IP source guard inactive addresses.
13.18 show ip source-guard statistics
Use the show ip source-guard statistics EXEC mode command to display the
Source Guard dynamic information (permitted stations).
Syntax
show ip source-guard statistics [
vlan vlan-id ]
Parameters
• vlan-id —Display the statistics on this VLAN.
Command Mode
User EXEC mode
Example
switchxxxxxx# show ip source-guard statistics
VLAN Statically Permitted Stations DHCP Snooping Permitted Stations
---- ------------------------------- --------------------------------
22 3
switchxxxxxx# show ip source-guard inactive
TCAM resources search frequency: 60 seconds
Interface
--------
gi12
gi13
gi14
Filter
-----
IP
IP
I
IP
Address
---------
10.1.8.32
MAC Address
-----------
0060.704C.8
3FF
VLAN
-----
3
Type
----
DHCP
Reason
----------
Resource
Problem
Trust port