Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 766
36
User Guidelines
Each port can advertise one IP address.
Example
The following example sets the LLDP management address advertisement mode
to automatic on gi12.
switchxxxxxx(config)# interface gi12
switchxxxxxx(config-if)# lldp management-address automatic
36.6 lldp med
To enable or disable LLDP Media Endpoint Discovery (MED) on a port, use the lldp
med Interface (Ethernet) Configuration mode command. To return to the default
state, use the no form of this command.
Syntax
lldp med {
enable [ tlv … tlv4 ] | disable }
no lldp med
Parameters
• enable—Enable LLDP MED
• tlv—Specifies the TLV that should be included. Available TLVs are:
Network-Policy, Location, and POE-PSE, Inventory. The Capabilities TLV is
always included if LLDP-MED is enabled.
• disable—Disable LLDP MED on the port
Default Configuration
Enabled with network-policy TLV
Command Mode
Interface (Ethernet) Configuration mode