Cisco Sx350

MLD Snooping Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 844
42
Parameters
N/A
Default Configuration
Enabled
Command Mode
Global Configuration mode
User Guidelines
To run the MLD Snooping querier on a VLAN, you have enable it globally and on the
VLAN.
Example
The following example disables the MLD Snooping querier globally:
switchxxxxxx(config)# no ipv6 mld snooping querier
42.4 ipv6 mld snooping vlan querier
To enable the Internet MLD Snooping querier on a specific VLAN, use the ipv6 mld
snooping vlan querier command in Global Configuration mode. To return to the
default, use the no form of this command.
Syntax
ipv6 mld snooping
vlan vlan-id querier
no ipv6 mld snooping
vlan vlan-id querier
Parameters
• vlan-id —Specifies the VLAN.
Default Configuration
Disabled