Cisco Sx350

Radius Server Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 980
49
Example
The following example defines port 2083 as an accounting UDP port:
switchxxxxxx(config)# accounting-port 2083
49.7 radius server authentication-port
To define the authentication UDP port used for authentication requests, use the
radius server authentication-port command in Global Configuration mode. To
restore the default configuration, use the no form of this command.
Syntax
radius server authentication-port
udp-port
no radius server authentication-port
Parameters
• udp-port —Specifies the UDP port number for authentication requests.
(Range: 1–65535)
Default Configuration
1812
Command Mode
Global Configuration mode
User Guidelines
Use the radius server authentication-port command, to define an UDP port for
authentication requests.
Use the no radius server authentication-port command, to restore the default UDP
authentication port.
Example
The following example defines port 2083 as an authentication UDP port:
switchxxxxxx(config)# authentication -port 2083