Cisco Sx350

Authentication, Authorization and Accounting (AAA) Commands
179 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
5
.
HTTP, HHTPS: Radius, local
Dot1x: Radius
5.7 password
Use the password Line Configuration mode command to specify a password on a
line (also known as an access method, such as a console or Telnet). Use the no
form of this command to return to the default password.
Syntax
password
password [encrypted]
no password
Parameters
• password —Specifies the password for this line. (Length: 0–159 characters)
• encrypted—Specifies that the password is encrypted and copied from
another device configuration.
Default Configuration
No password is defined.
Command Mode
Line Configuration Mode
Example
The following example specifies the password ‘secret’ on a console.
switchxxxxxx(config)# line console
Line
--------------
Console
Telnet
SSH
Login Method List
-----------------
Console_Login
Default
Default
Enable Method List
------------------
Console_Enable
Default
Default