Cisco Sx350

ACL Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 74
2
2.16 show access-lists
Use the show access-lists Privileged EXEC mode command to display access
control lists (ACLs) configured on the switch.
Syntax
show access-lists [
name ]
show access-lists time-range-active [name]
Parameters
• name—Specifies the name of the ACL.(Range: 1-160 characters).
• time-range-active—Shows only the Access Control Entries (ACEs) whose
time-range is currently active (including those that are not associated with
time-range).
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show access-lists
Standard IP access list 1
Extended IP access list ACL2
permit 234 172.30.19.1 0.0.0.255 any
priority 20 time-range weekdays
permit 234 172.30.23.8 0.0.0.255 any
priority 40 time-range weekdays
switchxxxxxx# show access-lists time-range-active
Extended IP access list ACL1
permit 234 172.30.40.1 0.0.0.0 any
priority 20
permit 234 172.30.8.8 0.0.0.0 any priority 40
Extended IP access list ACL2
permit 234 172.30.19.1 0.0.0.255 any
priority 20time-range weekdays
switchxxxxxx# show access-lists ACL1