EasyManuals Logo

Cisco Sx350 User Manual

Cisco Sx350
1323 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #880 background imageLoading...
Page #880 background image
Network Management Protocol (SNMP) Commands
879 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
43
Example
The following example displays the SNMP engine ID.
switchxxxxxx#
show snmp engineID
Local SNMP engineID: 08009009020C0B099C075878
IP address Remote SNMP engineID
----------- -------------------------------
172.16.1.1 08009009020C0B099C075879
43.18 snmp-server enable traps
To enable the device to send SNMP traps, use the snmp-server enable traps
Global Configuration mode command. To disable all SNMP traps, use the no form
of the command.
Syntax
snmp-server enable traps
no snmp-server enable traps
Default Configuration
SNMP traps are enabled.
Command Mode
Global Configuration mode
User Guidelines
If no snmp-server enable traps has been entered, you can enable failure traps by
using snmp-server trap authentication as shown in the example.
Example
The following example enables SNMP traps except for SNMP failure traps.
switchxxxxxx(config)#
snmp-server enable traps
switchxxxxxx(config)#
no snmp-server trap authentication

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Sx350 and is the answer not in the manual?

Cisco Sx350 Specifications

General IconGeneral
BrandCisco
ModelSx350
CategorySwitch
LanguageEnglish

Related product manuals