Cisco Sx350

IPv6 First Hop Security
679 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
29
Parameters
• enable—Enables logging of Binding table main events. If no keyword is
configured, this keyword is applied by default.
• disable—Disables logging of Binding table main events.
Default Configuration
Policy attached to port or port channel: the value configured in the policy attached
to the VLAN.
Policy attached to VLAN: global configuration.
Command Mode
Neighbor Binding Policy Configuration mode.
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.
Example
The following example enables logging of Binding table main events within the
IPv6 Neighbor Binding policy named policy1:
switchxxxxxx(config)# ipv6 neighbor binding policy policy1
switchxxxxxx(config-nbr-binding)# logging binding enable
switchxxxxxx(config-nbr-binding)# exit
29.53 logging packet drop
To enable the logging of dropped packets within an IPv6 First Hop Security policy,
use the logging packet drop command in IPv6 First Hop Security Policy
Configuration mode. To return to the default, use the no form of this command.
Syntax
logging packet drop [enable | disable]
no logging packet drop