Cisco Sx350 User Manual

Link Layer Discovery Protocol (LLDP) Commands
787 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
36
LLDP is disabled.
36.25 show lldp local tlvs-overloading
When an LLDP packet contains too much information for one packet, this is called
overloading. To display the status of TLVs overloading of the LLDP on all ports or
on a specific port, use the show lldp local tlvs-overloading EXEC mode command.
Syntax
show lldp local tlvs-overloading
[interface-id]
Parameters
interface-id—(Optional) Specifies a port ID.
Default Configuration
If no port ID is entered, the command displays information for all ports.
Command Mode
User EXEC mode
User Guidelines
The command calculates the overloading status of the current LLDP configuration,
and not for the last LLDP packet that was sent.
Example
switchxxxxxx# show lldp local tlvs-overloading gi11
TLVs Group Bytes Status
------------ ------ --------------
Mandatory 31 Transmitted
LLDP-MED Capabilities 9 Transmitted
LLDP-MED Location 200 Transmitted
802.1 1360 Overloading
Total: 1600 bytes
Left: 100 bytes

Cisco Sx350 Specifications

General

Brand	Cisco
Model	Sx350
Category	Switch
Language	English