Cisco Sx350

Rate Limit and Storm Control Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 1008
50
Syntax
show rate-limit vlan [ vlan-id ]
Parameters
• vlan-id —(Optional) Specifies a VLAN ID If the argument is not configured
rate limit configuration of all VLANs is displayed.
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Examples
The following is an example of the output from the show rate-limit vlan:
switchxxxxxx> show rate-limit vlan 1075
50.7 show storm-control interface
To display storm control information of an interface, use the show storm-control
interface command in Privileged EXEC mode.
Syntax
show storm-control interface [ interface-id ]
Parameters
• interface-id —(Optional) Specifies an Ethernet port. If the argument is not
configured storm control information of all Ethernet ports is displayed.
VLAN
--------
1075
Rate Limit (kbps)
----------------------
-
100000
Burst (Bytes)
----------------
-
1024