Cisco Sx350

IPv6 First Hop Security
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 608
29
Default policies can never be deleted. You can only delete the user-added
configuration.
Lists of Commands
29.1 address-config
To specify allowed configuration methods of global IPv6 addresses within an IPv6
Neighbor Binding policy, use the address-config command in Neighbor Binding
Policy Configuration mode. To return to the default, use the no form of this
command.
Syntax
address-config [stateless | any] [dhcp]
no address-config
Parameters
• stateless—Only auto configuration for global IPv6 bound from NDP
messages is allowed.
• any—All configuration methods for global IPv6 bound from NDP messages
(stateless and manual) are allowed. If no keyword is defined the any
keyword is applied.
• dhcp—Bound from DHCPv6 is allowed.
Default Configuration
Policy attached to port or port channel: the value configured in the policy attached
to the VLAN.
Policy attached to VLAN: global configuration.
Command Mode
Neighbor Binding Policy Configuration mode.
User Guidelines
If this command is part of a policy attached to a VLAN, it is applied to all the ports
in the VLAN. If it is defined in a policy attached to a port in the VLAN, this value
overrides the value in the policy attached to the VLAN.