Cisco Sx350

Macro Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 806
38
@
Example 2 -The following example shows how to create a macro with the
parameters: DUPLEX and SPEED. When the macro is run, the values of DUPLEX
and SPEED must be provided by the user. The #macro keywords command
enables the user to receive help for the macro as shown in Example 3.
switchxxxxxx(config)# macro name duplex
Enter macro commands one per line. End with the character ‘@’.
duplex $DUPLEX
no negotiation
speed $SPEED
#
macro keywords $DUPLEX $SPEED
@
Example 3 -The following example shows how to display the keywords using the
help character ? (as defined by the #macro keywords command above) and then
run the macro on the port. The #macro keywords command entered in the macro
definition enables the user to receive help for the macro, as shown after the words
e.g. below.
switchxxxxxx(config)# interface gi11
switchxxxxxx(config-if)# macro apply duplex ?
WORD <1-32> Keyword to replace with value e.g. $DUPLEX, $SPEED
<cr>
switchxxxxxx(config-if)# macro apply duplex $DUPLEX ?
WORD<1-32> First parameter value
<cr>
switchxxxxxx(config-if)# macro apply duplex $DUPLEX full $SPEED ?
WORD<1-32> Second parameter value
switchxxxxxx(config-if)# macro apply duplex $DUPLEX full $SPEED 100
38.2 macro
Use the macro apply/trace Interface Configuration command to either: