Cisco Sx350

IPv4 IPM Router Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 548
27
vlan100, 5:29:15/0:02:57
(192.168.46.0/24, 224.0.255.3), 05:29:15/00:02:59
Incoming interface: vlan2
Outgoing interface list:
vlan5, 05:29:15/00:02:57
27.4 show ip multicast
To display general information about IP Multicast configuration, use the show ip
multicast command in user EXEC or privileged EXEC mode.
Syntax
show ip multicast [interface interface-id ]
Parameters
• interface—Displays IP Multicast-related information about an interface
configured for IP Multicast.
• interface-id —Interface identifier for which to display IP Multicast
information.
Command Mode
User EXEC mode
Privileged EXEC mode
User Guidelines
Use the show ip multicast command without the interface keyword to display
general information about the state of IP Multicast on the router.
Use the show ip multicast command with the interface keyword to display the IP
Multicast information about the specified interface.
Examples
Example 1. The following is sample output from the show ip multicast command
without the interface keyword when no IP Multicast Routing protocol is enabled:
switchxxxxxx# show ip multicast