Cisco Sx350

Address Table Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 158
4
Syntax
show bridge multicast mode [
vlan vlan-id ]
Parameters
vlan
vlan-id —(Optional) Specifies the VLAN ID.
Command Mode
Privileged EXEC mode
Example
The following example displays the Multicast bridging mode for all VLANs
switchxxxxxx# show bridge multicast mode
4.28 show bridge multicast address-table
To display Multicast MAC addresses or IP Multicast address table information, use
the show bridge multicast address-table Privileged EXEC mode command.
Syntax
show bridge multicast address-table [vlan
vlan-id ]
show bridge multicast address-table [vlan
vlan-id ] [address
mac-multicast-address
] [format {ip | mac}]
show bridge multicast address-table [vlan vlan-id ] [address
ipv4-multicast-address]
[source ipv4-source-address ]
VLAN IPv4 Multicast Mode IPv6 Multicast Mode
Admin Oper Admin Oper
----- ----------- ----------- ----------- -----------
1 MAC-GROUP MAC-GROUP MAC-GROUP MAC-GROUP
11 IPv4-GROUP IPv4-GROUP IPv6-GROUP IPv6-GROUP
12 IPv4-SRC-
GROUP
IPv4-SRC-
GROUP
IPv6-SRC-
GROUP
IPv6-SRC-
GROUP