Cisco Sx350

SSH Client Commands
1153 Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide
59
n24VYtYtsMu74qXviYjziVucWKjjKEb11juqnF0GDlB3VVmxHLmxnAz643WK42Z7dLM5
sY29ouezv4Xz2PuMch5VGPP+CDqzCM4loWgV
---- END SSH2 PRIVATE KEY ----
Example 3. The following example displays the SSH client authentication method,
the username and the password:
switchxxxxxx# show ip ssh-client
Source IPv4 interface: vlan 1
Source IPv6 interface: vlan 10
Authentication method: DSA key
Username: anonymous (default)
Password: anonymous (default)
password(Encrypted): KzGgzpYa7GzCHhaveSJDehGJ6L3Yf9ZBAU5nsxSxwic=
59.11 show ip ssh-client server
To display the SSH remote server authentication method and the Trusted Remote
SSH Server table, use the show ip ssh-client server command in Privilege EXEC
Configuration mode.
Syntax
show ip ssh-client server [
host | ip-address ]
Parameters
• host —(Optional) DNS name of an SSH server.
• ip-address —(Optional) IP Address of an SSH server. The IP address can be
an IPv4, IPv6 or IPv6z address. See IPv6z Address Conventions.
Default Configuration
None
Command Mode
Privileged EXEC mode