Cisco Sx350

Link Layer Discovery Protocol (LLDP) Commands
Cisco Sx350 Ph. 2.2.5 Devices - Command Line Interface Reference Guide 768
36
36.8 lldp med fast-start repeat-count
When a port comes up, LLDP can send packets more quickly than usual using its
fast-start mechanism.
To configure the number of packets that is sent during the activation of the fast
start mechanism, use the lldp med fast-start repeat-count Global Configuration
mode command. To return to default, use the no form of this command.
Syntax
lldp med fast-start repeat-count
number
no lldp med fast-start repeat-count
Parameters
repeat-count
number —Specifies the number of times the fast start LLDPDU is
being sent during the activation of the fast start mechanism. The range is 1-10.
Default Configuration
3
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# lldp med fast-start repeat-count 4
36.9 lldp med location
To configure the location information for the LLDP Media Endpoint Discovery
(MED) for a port, use the lldp med location Interface (Ethernet) Configuration mode
command. To delete location information for a port, use the no form of this
command.
Syntax
lldp med location
{{coordinate data} | {civic-address data} | {ecs-elin data}}
no lldp med location {coordinate | civic-address | ecs-elin}